欢迎光临山东德旭达土工材料有限公司网站!
搜索关键词:    土工布 土工膜 防渗膜

新闻中心

防渗膜焊接设备的常见故障及排除

防渗膜焊接设备的常见故障及排除

1、现象原因消除

2、防渗膜焊接设备没有热气。热气马达不工作。换个新的马达。

3、热芯未加热更换新的热芯

4、防渗膜焊接设备侧面插座被物品堵塞,请清洁插座。

5、出料口被卡住,发出声音和震动,延长预热时间,清洗出料口

6、防渗膜焊接设备螺钉或刀片磨损或磨损更换新螺钉或刀片

7、防渗膜卡在螺丝或刀片中,打开进料罩并清洁被卡物品。

8、无驱动电机碳刷磨损寿命后更换新碳刷

9、电机因过电压而烧毁更换新电机

10、防渗膜焊接设备电线松动,重新连接电线

11、不能送料的材料电极插入不够深,重新放置电极

12、电极不能插入进料口,只能放入上料孔(φ4.5mm孔)

13、螺钉磨损导致间隙过大更换新螺钉

The Familiar Malfunction  and elimination

Phenomena Reason The was of eliminate 

NO hot air The hot air motor doesn’t work Change a new motor

The hot core is not heated Change a new hot core

The side outlets are jammed with articles Clean the outlets

Sounds and shake happens Discharging mouth being jammed Prolong the preheating time and clean the discharging mouth

Wear and tear of the screw or blade Change new screw or blade

The article are jammed in the screw or blade Open the feeding shelter and clean the jammed article

no driving motor Carbon brush wear and tear after life span Change a new carbon brush

motor burned caused by overvoltage Change a new motor

Loosed electrical wiring reconnecting the wiring

The materials can’t be fed Electrode was not inserted deep enough Put the electrode again

Electrode cannot be inserted into the feed opening φ4mmElectrode only can be put into the upper material hole(φ4.5mm hole)

Worn screw leads an excessive clearance Change a new screw


相关内容推荐:

热门产品推荐

POPULAR PRODUCTS

企业风采

Corporate Style
展开